23
CONTACT CSI FOR MORE INFORMATION | CSIDESIGNS.COM | [email protected] | +1.417.831.1411
MAINTENANCE
REPLACING COMPONENTS
The instructions below describe how to replace components used in the manu-
facturing of a Compact CIP control system .
REPLACING POLY TUBING
1 . Ensure that the Control Panel is powered down .
2 . Disconnect the inbound airline at the pressure regulator .
3 . Press in the outer ring of the pneumatic fitting, and then gently pull the
cracked or leaking airline from the fitting .
4 . Repeat the same procedure for the other end of the airline .
5 . Use the cracked or leaking airline as a guide for the length of the new air-
line .
6 . Trim the new section of airline to the appropriate length .
7 . Install airline by pressing each end into pneumatic fittings .
Note:
Make certain the outer rings on the pneumatic fittings extend after the
new line is pressed in . If fittings are not fully extended outward, the hose could
be blown out from its seated position when subjected to sufficient pressure .
