CRZ ERZ Series, Manual

Page: 84 / 127

84
Third. Cooling system
1. Water tank
The water tank is located at the front of the engine. According to the environment
you are driving, the water tank should be cleaned regularly for dust and dirt.
2. Cooling fluid
The cooling fluid should be maintained according to the “Maintenance Schedule”.
When adding or replacing cooling fluid, do not use non-glycol cooling fluid, tap water or
mineral water. Improper use of cooling fluid can cause damage, such as corrosion in the
engine, blockage of cooling passages or radiators, and premature wear of the pump seal.
Please use special coolant:
(1) Check the capacity of cooling water
(2) You need to put the motorcycle in a horizontal position when you are checking
it;
(3) You need to check it after the engine cooling down;
(4) You need to ensure the cooling water between to the up and down scale.
(5) Adding the cooling fluid
If the position of the cooling fluid is at or below the 3 mark, please add special
cooling fluid to the 2 mark line. Methods as follows ;
(1) Put the motorcycle in a horizontal position;
(2) Open the right tank cover 1 and add the coolant to the 2 upper marking position;
(3) Start the engine, let the cooling water circulate in the engine, and observe the
position of the cooling fluid liquid level if it is insufficient;
(4) Install the tank cover 1
(5) Change the cooling fluid
(6) Put the container under the engine;
(7) Remove the bolt 4;
(8) Loosen the tank cover and tilt the vehicle to the right as far as possible to drain
the cooling fluid. When the radiator cap is loose, the cooling fluid will be sprayed
laterally; therefore, the container is brought near the exit;