Operation Instructions
32
/
55
be activated, and drum first rotates to a position where plate pressing roller is engaged to press and
support on the plate before drum further continues to rotate until plate mounting comes to the
plate end position. At this time, both
,
buttons’lights are flashing, awaiting to be
pressed for next operating action.
e)
Having plate mounting now come close to the plate end(plate tail), you may need to inspect and
observe the plate mounting position straightness and condition on drum before continue:
e-1)If plate mounted position is straight and correct, used 3M tape(or other high adhesive tapes)to
stick and patch on the plate tail edge . Note that the patch width should be greater than 5mm.
Press the
button, loading platform will reverse and lift upward (drum uncover). At this time,
both
,
buttons’ lights are flashing, and awaiting to be pressed for next operating
action.
e-2) If found plate mounted positing is slant or incorrect, press the
button, the HDI device
will return to “
c)
” state, which further allow user to manual adjust and correct the plate loading
and mounting position.
f)
Once plate completely mounted and loading platform is reversed and lifted up from drum
surface(not close: