Operation Instructions
28
/
55
button to have the tail Clamp closed and clamped on the plate. At this point,
,
,
buttons lights are flashing, and awaiting to be pressed for next operating action.
d-2)If found Tail Clamp position beyond or more than 2±1mm, you need to manually adjust the
Tail Clamp shaft position, either press on the
button to have Drum rotates clockwise
2mm distance each time, or press on
button, to have Drum rotates anti-clockwise 2mm
distance. This action is to allow the plate end on Drum to reposition closer to the Tail Clamp shaft
position in order for plate tail clamping.
Confirm that plate end entry to Tail Clamp shaft having depth is greater than 4mm and not getting
any obstruction by the Tail Clamp shaft, press
button to close the Tail Clamp. At this point,
,
,
buttons lights are flashing, and awaiting to be pressed for next operating
action.
e) Press the
button, device will returns to d) status,you can readjust the position of the Tail
Clamp, to avoid or correct previous manual adjustment deviation;
Press the
button,to enter to Engineer adjustment mode. No further explanation needed
on this;
Press the
button, to enter to Output operation mode. At this point, return the device’s
cover to its original closing position, the device has completed the plate mounting and clamping
process,and further proceed to automatic plateoutput process(imaging).
5.5.2 Plate unloading process:
a) Upon job “Output” process completed, or under the command process of “Unload Plate”, device
will enter into unloading procedures.
c)
Open the device’s upper cover and slide it back to open position, at this point the device is ready
for plate unloading process. Plate end has already being released and away from Tail Clamp, and
Drum rotates to the unload position,
button light is flashing, awaiting to be pressed for next