ILT Shade Controller
Crestron
C2N-SSC-2
8
•
ILT Shade Controller: C2N-SSC-2
Operations & Installation Guide - DOC. 6318
NOTE:
All Cresnet wiring must consist of two twisted pairs. One twisted
pair is the +24V conductor and the GND conductor, and the other twisted
pair is the Y conductor and the Z conductor.
NOTE:
When daisy-chaining Cresnet units, strip the ends of the wires
carefully to avoid nicking the conductors. Twist together the ends of the
wires that share a pin on the network connector, and tin the twisted
connection. Apply solder only to the ends of the twisted wires. Avoid
tinning too far up the wires or the end becomes brittle. Insert the tinned
connection into the Cresnet connector and tighten the retaining screw.
Repeat the procedure for the other three conductors.
Identity Code
Every equipment and user interface within the network requires a unique
identity code (Cresnet ID or Net ID). These codes are two-digit
hexadecimal numbers from 03 to FE. The Net ID of each unit must match
an ID code specified in the SIMPL Windows program. Refer to “Setting
the Net ID in Device Settings” on page 20 for details of the SIMPL
Windows procedure.
Refer to note
on page 27
for a
definition of
Viewport.
The Net ID of the C2N-SSC-2 has been factory set to
0C
. The Net IDs of
multiple Shade Controllers in the same system must be unique. Net IDs are
changed from a personal computer (PC) via the Crestron Viewport.
NOTE
: For detailed information on establishing communication between
the PC and control system, refer to “Communication Settings” on page
27. If communication cannot be established, refer to the
“Troubleshooting Communications” section in the latest version of the
2-Series Control System Reference Guide (Doc. 6256), which is
available from the Downloads | Product Manuals section of the Crestron
website (www.crestron.com). For other control systems, refer to the
respective Operations Guide.
There are two different methods—Method A or Method B—for setting
the Shade Controller Net IDs:
Method A
(Cresnet address-settable ID), described on the next page,
applies to all Shade Controllers in a Cresnet system. This method
