ILT Shade Controller
Crestron
C2N-SSC-2
6
•
ILT Shade Controller: C2N-SSC-2
Operations & Installation Guide - DOC. 6318
−
On for one second, then off when shade reversal is executed
from buttons on the unit.
SETUP LED and Pushbutton
The SETUP pushbutton and its associated LED are used for setup of the
unit’s network ID during the initial configuration of a Cresnet system or
when the device is being added/replaced. Refer to “Method B (Touch
Settable IDs)” on page 10
for detailed information.
Industry Compliance
As of the date of manufacture, the Shade Controllers have been tested
and found to comply with specifications for CE marking and standards
per EMC and Radiocommunications Compliance Labelling.
NOTE:
This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Setup
Network Wiring
CAUTION:
Use only Crestron power supplies for Crestron equipment.
Failure to do so could cause equipment damage or void the Crestron
warranty.
CAUTION:
Provide sufficient power to the system. Insufficient power
can lead to unpredictable results or damage to the equipment. Please use
the Crestron Power Calculator to help calculate how much power is
needed for the system.
<http://www.crestron.com/dealer-tech_resources/power_calculator.asp>
NOTE:
When installing network wiring, refer to the latest revision of the
wiring diagram(s) appropriate for your specific system configuration,
