Crestron
C2N-SSC-2
ILT Shade Controller
Operations & Installation Guide - DOC. 6318
ILT Shade Controller: C2N-SSC-2
•
13
Overview
Installation consists of mounting the Shade Controller (using either the
Dual Lock fastener or screws, as desired) in a location that is out of
casual reach, but within fifty feet of the shade(s) it controls; connecting a
Cresnet cable to the NET port; connecting the interface cable(s) from the
shade(s) to the RJ-11 port(s), and setting the upper and lower limits of
travel for the shade(s).
1. Turn Cresnet system power
OFF
.
2. Connect the Cresnet cable with supplied mate to the Shade
Controller’s Cresnet port and the other end to the control
system.
3. Connect the modular cable from the shade(s) to the Shade
Controller RJ-11 port(s). If a longer modular cable is required,
fabricate using standard 4-wire modular cable with 4-pin
(4 body size) modular plugs.
−
Invert the plugs on the same cable. When the plugs are
held side by side, the wires are in the same order (refer to
following graphic).
−
Check that the connector is correctly crimped.
Setting Shade Limits and Direction of Travel
When an ILT shade is first installed, the limits of travel will normally
come “pinched” together so that the shade will not move up or down.
Limits and travel direction for an ILT shade are not set mechanically, but
are stored electronically in the shade motor itself. Limits of travel must
be set for each shade in order for the shade to operate properly. The six
