Creo Dolev 800V+, User Manual

Page: 59 / 90

The Output Cassette 49
Developing Film with Off-line Processor
1.
Carry the output cassette to a darkroom which is equipped with a
bright cyan light.
2.
Close the developing room door and lock it. Turn
on
the cyan light.
3.
To open the output cassette, press the three (3) fasteners on the front
of the cassette and open the cassette lid upwards.
4.
Remove the exposed films one at a time, and feed each piece of film
into the processor.
5.
Depending on your processor, you receive a signal from the processor
when you are allowed to feed each subsequent film. When you have
fed the last film into the processor and received the signal that the feed
is complete, you may unlock the door.
6.
Load the output cassette back into the imagesetter, and close the
output cassette door.
CAUTION: Do not open the output cassette until you are in the developing
area and the door is LOCKED .
Note: You may find one narrow strip of film in the cassette (less than 4
inches wide). This is the piece of film that was exposed to light when a new
supply cassette was loaded onto the imagesetter. Dispose of this waste film.
Note: Be sure to check the bottom and sides of the cassette carefully for any
film that may have slid into the base of the cassette.