Creo Dolev 800V+, User Manual

Page: 66 / 90

56 Chapter 3 – Media Management
Removing Stuck Film from the Imagesetter
The only maintenance procedure you are allowed to perform is removing
film (supply media) stuck on the inside of the imagesetter drum area.
Please refer to the Safety Precautions chapter for details on laser and other
safety precautions before proceeding.
To remove film stuck in the Imagesetter, proceed as follows:
1.
Switch
off
the imagesetter, using the Master circuit breaker at the lower
rear side of the imagesetter.
2.
To access the inside of the imagesetter drum area, open the left or
right service door, or both side doors (to do so, unscrew the thumb
screw(s) accessible from the Unloading cassette compartment).
3.
Locate the black protective cover on each side of the imagesetter
drum.
4.
Unfasten the two (2) capture screws that secure the cover to the frame
of the imagesetter.
5.
Remove the cover and store it on a clean surface.
6.
Clear the film stuck in the machine.
7.
Replace the side covers; secure the side covers with their thumb
screws.
8.
Close the side door(s); secure the side door(s) with their screws.