Cosen SVT-6070H, Instruction Manual

Page: 59 / 106

4-23
BREAKING-IN THE BLADE
When a new saw blade is used, be sure to first break in the blade before using it for actual, extended
operation. Failure to break in the blade will result in less than optimum efficiency. To perform this
break-in operation, the following instructions should be followed:
Step 1 - Reduce the blade speed to one-half of its normal setting.
Step 2 - Lengthen the cutting time to 2-3 times of what is normally required.
Step 3 -The complete break-in operation requires cutting on a 645 mm
2
(25.4 square inches) section
for 5 times.
Step 4 - After the break-in operation is completed, set all parameters back to normal settings.
TERMINATING A CUTTING OPERATION
STOP
•
To terminate a cutting operation, press either the
workbed to the right
button or the
emergency
stop
button.
•
The saw blade will stop running when the
workbed to the right
button is pressed.
•
Both the saw blade and hydraulic pump motors will stop running when the
emergency stop
button is pressed.
•
The machine will stop automatically when an error occurs. The error message will be shown on
the screen.