29 of 64
CORRADI S.R.L.
- INSTALLATION MANUAL - PERGOTENDA ® MAESTRO
REV.1 - 11.2019
6 TRANSMISSION SHAFT INSTALLATION
Fig. 34 - Shaft installation
- Slide shaft (
A
) until inserting it into the motor hexagon pin (
B
);
- if the two hexagon ends (male and female) do not match, slightly rotate shaft (
A
) keeping it against
the motor until the first engagement point;
- tighten screw (
B
).
A
B
Note
: to set the motor, refer to the instructions provided inside the control unit box; otherwise,
you can find them in the reserved area of the CORRADI.EU website.
Fig. 35 - Shaft installation
- Perform a general tightening check of the motor shaft screws;
- Check that the movements are correct by temporarily connecting the electric motor.
Note
: then, perform a final tightening of each runner retaining screw.
C
