31 of 64
CORRADI S.R.L.
- INSTALLATION MANUAL - PERGOTENDA ® MAESTRO
REV.1 - 11.2019
8 IMPACT AWNING CANVAS INSTALLATION
Fig. 37 - Canvas installation on runners
- Position the lifting kits of the side runners by hanging them on the screws/washers (
det. Y
) on the runner channels.
- To prevent lifting kit deformations, fit a duly sized wooden block inside space
“X”.
- In case of 3 runners, the lifting kits on the central runner (standard method) must be positioned at maximum 50 cm from the motor beam to prevent the central runner from bending during the lifting.
- Start by inserting the front terminal tube (
D1
) on the first slider (
C1
); then insert the other tubes, except the last terminal on motor side
(D2
).
- Activate the awning closure by moving the already inserted sliders closer to the last fixed one (
C2
). Then, fit the terminal tube (
D2
) on slider (
C2
) and tighten the retaining nut. Adjust the limit switches (see relevant
chapter) and fit the closing covers (
E
).
NOTE:
The nuts of the drive slider (
C1
) and of the fixed one (
C2
) must be tightened until the terminal plug perfectly adheres against the slider.
The intermediate slider nuts must be slightly tightened, i.e. only until the end of the thread, without further forcing.
C1
D1
E
D2
C2
X
Dett. Y
