CORBERO CC900X, User Manual

Page: 23 / 167

23
Gas Connection
WARNING: Before starting any work related with gas installation, turn off gas
supply. Risk of explosion.
Please operate your oven in dry atmosphere.
1. Fit the clamp to the hose. Push one of the hose until it goes to the end of
the pipe.
2. For the sealing control; ensure that the buttons in the control panel are
closed, but the gas cylinder is open. Apply some soap bubbles to the
connection. If there is gas leakage, there will be foaming in the soaped area.
3. The oven should be using a well ventilation place and should be
install on flat ground.
4. Re-inspect the gas connection.
5. When placing your oven to its location, ensure that it is at the counter
level. Bring it to the counter level by adjusting the feet if necessary.
6. Do not make gas hose and electrical cable of your oven go through theheated
areas, especially through the rear side of the oven. Do not move gas connected oven.
Since the forcing shall loosen the hose, gas leakage may occur.
7. Please use flexible hose for gas connection.
For LPG connection;
1. For LPG (cylinder) connection, affix metal
clamp on the hose coming from LPG cylinder.
Affix an edge of the hose on hose inlet
connector behind the appliance by pushing
to end through heating the hose in boiled
water. Afterward, bring the clamp towards
end section of the hose and tighten it with
screwdriver. The gasket and hose inlet
connector required for connection is as the
picture shown below.
NOTE: The regulator to be affixed on LPG cylinder should have 300
mmSS feature.
Main Gas Pipe
Gasket
Hose Inlet Connector
Metal Clamp
Lpg Connection Hose