4-9
Compaq ProLiant 6000 Setup and Installation Guide
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Sam Ogden Project: Compaq ProLiant 6000 Setup and Installation Guide Comments: 312237-003 (February 1999)
File Name: E-CH04.DOC Last Saved On: 2/22/99 8:55 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
4.
Open the ejector levers
on the processor terminator board and remove
it by pulling it out by the handle
. Retain for future use.
NOTE
: If you remove a processor, the processor terminator board must be
re-installed before powering up the server.
1
1
2
Figure 4-8. Removing the processor terminator board
5.
Locate the processor bus/core ratio switch for the processor socket that
will receive the new processor. See Table 4-1 or the right side access
panel label.
6.
Set the processor bus/core ratio switch to the appropriate setting.
Table 4-2
Processor Bus/Core Ratio Switch Settings
Bus/Core Ratio
1
2
3
4
400-MHz models
ON
ON
ON
OFF
450-MHz models
OFF
ON
ON
OFF
500-MHz models
ON
ON
OFF
OFF
550-MHz models
OFF
ON
OFF
OFF
NOTE
: Compaq makes no representation or warranty that processors that operate at any
of the speeds shown will be available at any time.
