up from the system chassis and lifting it away from the computer.
To replace the board slots access plate, reverse Steps 1 through 3.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
CAUTION
Ensure that the retainers on the bottom side of the board slots access plate
fit securely onto each board installed in your computer.
If you changed to a
board of a different height, rotate the retainers to match the height of the
board.
If the retainers are not rotated, serious internal damage may result!
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
Chapter 7.5 High Voltage Access Plate Removal and Replacement
To remove and replace the high voltage access plate:
1.
Complete the Access Cover Removal Procedure (see Section 7.3).
2.
Loosen (DO NOT REMOVE) the six screws and the two 1/4 inch nuts securing
the high voltage access plate (Figure 7.5-1).
Slide the metal cover
toward the rear of the computer and lift it off.
To replace the high voltage access plate, reverse Steps 1 and 2.
Chapter 7.6 Mass Storage Device Access Plate Removal and Replacement
