>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
WARNING
Before removing the access cover from the COMPAQ Portable Computer, complete
the Preparation Procedure in Section 7.2.
If you have not completed the
preparation portion of this section, do so before continuing this procedure.
Failure to disconnect the computer from all AC voltage sources can cause
dangerous voltages to be present on the power supply and monitor.
Even when
the ON/OFF switch is set to the OFF position, any electrically conductive
material in this area could cause severe electrical shock.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
To remove the access cover:
1.
Complete the Preparation Procedure in Section 7.2.
2.
Place the curved end of the access cover lever in the first notch located
on the edge of the access cover near the handle.
The access cover lever
(PN 102935-001) is found with the test cable and plugs in the
Maintenance and Service Guide Kit.
Pry the corner of the access cover
away from the computer and insert a plastic card into the connecting seam
(Figure 7.3-1).
3.
Continue this procedure across the edge of the access cover, prying up at
each notch, until the cover pops loose.
4.
Once the cover is loosened, move it slightly back and lift it away from
the computer.
