1906 - 07
Tape already servo written
------------------------------------------------------------------------------
Error
Error
Required
Code
Description
Action
------------------------------------------------------------------------------
Tape Drive
19yy - xx
------------------------------------------------------------------------------
1906 - 08
Unable to servo write
The following steps apply to all
19yy - xx error codes:
1906 - 09
Unable to format
1.
Replace the tape cartridge.
1906 - 10
Format mode error
2.
Replace the signal cable.
3.
Replace the diskette/tape
1906 - 11
Drive recalibration error
controller board.
4.
Replace the tape drive
1906 - 12
Tape not servo written
assembly.
1906 - 13
Tape not formatted
* 286 based COMPAQ Personal
Computers only
1906 - 14
Drive timeout error
1906 - 15
Sensor error flag
1906 - 16
Block locate (block ID)
error
1906 - 17
Soft error limit exceeded
1906 - 18
Fixed error limit exceeded
1906 - 19
Write error (probably ID
error)
1906 - 20
NEC765 fatal error
1906 - 21
Got servo pulses 2nd time
but not 1st
1906 - 22
Never got to EOT after
servo check
==============================================================================
Chapter 5.4 Memory Error Codes
This section is divided into two parts.
The first part contains memory error
codes for the COMPAQ PORTABLE 286 Personal Computer.
The second part contains
memory error codes for the COMPAQ Portable and COMPAQ PLUS Personal Computers.
Memory error codes result when the system detects a memory fault during the
Power On Self Test or as a result of a diagnostic test.
The test programs
attempt to isolate the memory fault to a specific chip, then generate a
memory error code that specifies which memory chip to replace.
In some
cases, replacing the memory chip will not solve the problem because:
1) the
system may be unable to accurately determine which chip or chips are at
fault, or 2) the problem may be due to a failure in the memory support
circuitry, not the memory device.
