42
6.5 CLOSING / SECURING CLOSURE
6.5.1 Apply optional routing label inside lid or on tray cover.
6.5.2 Install port plugs into all unused ports including ground port if no ground wire. See photo 143.
6.5.3 Close lid. Ensure all port plugs, ground wire (if present) and cables are properly aligned.
Snap right side hinge, left side hinge, and then top hinge. Hinges can be closed using
screwdriver
or
by
hand.
See photos 144-146.
Large end of port plug
Photo # 143
Mini
-
OTE 300 Installation Guide
All
trademarks used in this publication are CommScope registered
201
9
CommScope Inc. All rights Reserv
ed
6
.5.4 Tighten security bolt. See photo 147.
Photo # 144
Close right side 1st
Photo # 145
Close left side 2nd
Photo # 146
Close top last
Photo # 147
Note:
Tighten the security bolt
with a torque limiting tool, like a
type 216C can wrench (shown)
or 25 in.-lbs. maximum
Note:
To
assist in
closing the
right side
latch, the
top can be
pressed
closed and
the security
screw can
be started to
hold the top
closed.
Then, the
right side
latch can be
closed.
Caution:
Be sure
black braid or spiral
tubing is in place to
avoid pinching when
closing lid.
