Mini-OTE 300 Installation Guide
All trademarks used in this publication are CommScope
registered
201
9
CommScope Inc. All rights Reserved
51
7.5 CLOSING / SECURING CLOSURE
7.5.1 Apply optional routing label inside lid or on tray cover.
7.5.2 Install port plugs into all unused ports. Including ground port if no ground wire. See photo 182.
7.5.3 Close lid. Ensure all port plugs, ground wire (if present) and cables are properly aligned.
Snap right side hinge, left side hinge, then top hinge. Hinges can be closed using
screwdriver
or
by hand.
See photos 183-185.
Large end of port plug
Photo # 182
7
.5.4 Tighten security bolt. See photo 186.
Photo # 183
Close right side 1st
Photo # 184
Close left side 2nd
Photo # 185
Close top last
Photo # 186
Note:
Tighten the security bolt
with a torque limiting tool, like a
type 216C can wrench (shown)
or 25 in.-lbs. maximum
Note:
To
assist in
closing the
right side
latch, the
top can be
pressed
closed and
the security
screw can
be started to
hold the top
closed.
Then, the
right side
latch can be
closed.
Caution:
Be sure
black braid or spiral
tubing is in place to
avoid pinching when
closing lid.
