16
Connection of Video Signals
The SOLO4 Central Receiver is provided with four composite video
output connectors labelled ‘Composite’, and four S-Video connectors
labelled ‘S-Video’.
Connect the four video output leads to the four BNC connectors labelled
‘Composite’ on the SOLO4 Central Receiver and connect the other end
of the four video leads to four video display devices.
Connector
Signal
Video BNC
75 ohm composite video output, PAL or NTSC
software selectable at the transmitter
Typically the video display device will be a high quality monitor.
It should be noted that for ease of use the domo SOLO4 Central
Receiver is fitted with a quad screen output, in which all four video
outputs are multiplexed into a quad screen and displayed on a single
screen. This output is labelled ‘Quad Monitor Composite’.
Connection of Audio Signals
Push the four LEMO connector cables provided into the four sockets
labelled ‘AUDIO’, taking care to align the connectors. Connect the
other end of four cables to the chosen audio output device.
Connector
Signal
Audio Plugs
Line level, 12dBu clip level, low impedance
source (20 ohm)
Typically the audio output device will be monitoring speakers.
Connection to IP LAN
The SOLO4 Central Receiver should be connected to an Ethernet port
for control and also for streaming video (if NETSTREAM option is fitted).
The 10/100BaseT Ethernet network should be connected to the RJ45
connector on the front of the unit labelled ‘ETH0’.
Note: ETH0 must be used ETH1 is not currently enabled
