27
The Receiver Tab
The Receiver tab describes parameters specific to the entire central
receiver. These parameters are shown below.
Configuration Tabs
Each of the four Receivers within the central receiver contains 8 pre-
stored configurations.
The configuration contains a complete description of the receiver,
including the frequency, encryption key etc. The user can easily swap
between configurations by selecting one of the 8 configuration tabs.
Changes to a configuration that are made while in that tab are
automatically saved to that configuration.
Users can store configurations to file or load them from file using the
‘Save’ and ‘Load’ Config buttons.
Input Signal Bandwidth
If the input signal is domo standard 2.5MHz or 1.25MHz, then the
‘Narrowband’ radio button should be selected. If the the input signal is
8, 7 or 6MHz DVBT, then the DVBT radio button should be selected.
Frequency Parameter
The frequency of operation of the receiver is set by typing a frequency
into the ‘Input Frequency’ field, frequency is in MHz.
Configuration
Tabs
Frequency
Parameter
RF Status
Fields
Scrambling
Parameters
Spectrum
Display
