Cisco N5010P-N2K-BE, Software Configuration Manual

Page: 315 / 704

S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
21-3
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01
Chapter 21 Using Cisco Fabric Services
CFS Distribution
Uncoordinated Distribution
Uncoordinated distributions are used to distribute information that is not expected to conflict with that
from a peer. Parallel uncoordinated distributions are allowed for a feature.
Coordinated Distribution
Coordinated distributions allow only one feature distribution at a given time. CFS uses locks to enforce
this. A coordinated distribution is not allowed to start if locks are taken for the feature anywhere in the
network. A coordinated distribution consists of three stages:
1.
A network lock is acquired.
2. The configuration is distributed and committed.
3.
The network lock is released.
Coordinated distribution has two variants:
•
CFS driven —The stages are executed by CFS in response to an feature request without intervention
from the feature.
• Feature driven—The stages are under the complete control of the feature.
Coordinated distributions are used to distribute information that can be manipulated and distributed
from multiple switches, for example, the port security configuration.
Unrestricted Uncoordinated Distributions
Unrestricted uncoordinated distributions allow multiple parallel distributions in the network in the
presence of an existing coordinated distribution. Unrestricted uncoordinated distributions are allowed to
run in parallel with all other types of distributions.
Enabling/Disabling CFS Distribution on a Switch
If the switch is provisioned with Fibre Channel ports, CFS over Fibre Channel is enabled by default. CFS
over IP must be explicitly enabled.
You can globally disable CFS on a switch to isolate the features using CFS from network-wide
distributions while maintaining physical connectivity. When CFS is globally disabled on a switch, CFS
operations are restricted to the switch.
To globally disable or enable CFS distribution on a switch, perform this task:
Command Purpose
Step 1
switch#
configure
switch(config)#
Enters configuration mode.
Step 2
switch(config)# no cfs distribute
Globally disables CFS distribution (CFS over Fibre
Channel or IP) for all applications on the switch.
switch(config)# cfs distribute
Enables (default) CFS distribution on the switch.