Cisco N5010P-N2K-BE, Software Configuration Manual

Page: 339 / 704

C H A P T E R
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
23-1
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01
23
Configuring Session Manager
This chapter describes how to configure the Session Manager features in Cisco NX-OS.
This chapter includes the following sections:
• Information About Session Manager, page 23-1
•
Configuration Guidelines and Limitations, page 23-1
• Configuring Session Manager, page 23-2
•
Verifying Session Manager Configuration, page 23-4
Information About Session Manager
Session Manager allows you to implement your configuration changes in batch mode. Session Manager
works in the following phases:
• Configuration session—Creates a list of commands that you want to implement in session manager
mode.
•
Validation—Provides a basic semantic check on your configuration. Cisco NX-OS returns an error
if the semantic check fails on any part of the configuration.
• Verification—Verifies the configuration as a whole, based on the existing hardware and software
configuration and resources. Cisco NX-OS returns an error if the configuration does not pass this
verification phase.
•
Commit—Cisco NX-OS verifies the complete configuration and implements the changes atomically
to the device. If a failure occurs, Cisco NX-OS reverts to the original configuration.
• Abort—Discards the configuration changes before implementation.
You can optionally end a configuration session without committing the changes. You can also save a
configuration session.
Configuration Guidelines and Limitations
Session Manager has the following configuration guidelines and limitations:
• Session Manager supports only the ACL feature.
•
You can create up to 32 configuration sessions.
• You can configure a maximum of 20,000 commands across all sessions.