6-156
Cisco Unified Communications Manager Managed Services Guide
OL-22523-01
Chapter 6 Cisco Unified Serviceability Alarms and CiscoLog Messages
Error-Level Alarms
Enum Definitions -IPAddressAttributes
Enum Definitions -IPV6AddressAttributes
Recommended Action
Actions to take vary depending on the reason specified for the endpoint unregistration. If the reason is
ConfigurationMismatch, go to the Device Configuration page in Cisco Unified CM Administration,
make a change to the Description field for this device, click Save, then reset the device. In the case of a
network connectivity or loss of KeepAlives problem, use network diagnostic tools and the Cisco Unified
CM Reporting tool to fix any reported network or Unified CM system errors. In the case of an endpoint
rehoming to the primary Unified CM node, watch for a successful registration of the device on the
primary node. In the case of a duplicate registration request, it may be a non-malicious occurrence due
to timing of an endpoint registering and unregistering; if duplicate registration requests continue or if
the same endpoint has different IP addresses, confirm the IP address on the physical device itself by
checking the settings on the device (settings button). If unregistration of this device was expected, no
action is required. Also, refer to the reason code descriptions for recommended actions.
28
FallbackInitiated—The device has initiated a fallback and will automatically reregister to a
higher-priority Unified CM. No action is necessary.
29
DeviceSwitch—A second instance of an endpoint with the same device name has registered
and assumed control. No action is necessary.
Value Definition
0
Unknown—The device has not indicated what this IPv4 address is used for
1
Administrative only—The device has indicated that this IPv4 address is used for administrative
communication (web interface) only
2
Signal only—The device has indicated that this IPv4 address is used for control signaling only
3
Administrative and signal—The device has indicated that this IPv4 address is used for
administrative communication (web interface) and control signaling
Value
Definition
0
Unknown—The device has not indicated what this IPv6 address is used for
1
Administrative only—The device has indicated that this IPv6 address is used for
administrative communication (web interface) only
2
Signal only—The device has indicated that this IPv6 address is used for control signaling only
3
Administrative and signal— The device has indicated that this IPv6 address is used for
administrative communication (web interface) and control signaling
