Cisco Catalyst 3560-X Series, Software Configuration Manual

Page: 372 / 1538

1-8
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Chapter 1 Configuring MACsec Encryption
Understanding Cisco TrustSec MACsec
This is an example of configuring and verifying MACsec on an interface:
Switch(config)# interface GigabitEthernet1/0/25
Switch(config-if)#
switchport access vlan 10
Switch(config-if)# switchport mode access
Switch(config-if)# macsec
Switch(config-if)#
authentication event linksec fail action authorize vlan 2
Switch(config-if)# authentication host-mode multi-domain
Switch(config-if)# authentication linksec policy must-secure
Switch(config-if)#
authentication port-control auto
Switch(config-if)# authentication violation protect
Switch(config-if)# mka policy replay-policy
Switch(config-if)#
dot1x pae authenticator
Switch(config-if)# spanning-tree portfast
Switch(config-if)# end
Switch#
show authentication sessions interface gigabitethernet1/0/25
Interface: GigabitEthernet1/0/25
MAC Address: 001b.2140.ec3c
IP Address: 1.1.1.103
User-Name: ms1
Status: Authz Success
Domain: DATA
Security Policy: Must Secure ß--- New
Security Status: Secured ß--- New
Oper host mode: multi-domain
Oper control dir: both
Authorized By: Authentication Server
Vlan Policy: 10
Session timeout: 3600s (server), Remaining: 3567s
Timeout action: Reauthenticate
Idle timeout: N/A
Common Session ID: 0A05783B0000001700448BA8
Acct Session ID: 0x00000019
Handle: 0x06000017
Runnable methods list:
Method State
dot1x Authc Success
Understanding Cisco TrustSec MACsec
Note
Cisco TrustSec MACsec for switch-to-switch security is supported only on switches running the IP base
or IP services feature set. It is not supported on switches running the NPE or LAN base feature set.
Table 1-2 summarizes the Cisco TrustSec features supported on the switch. For more detailed
explanations, see the Cisco TrustSec Switch Configuration Guide:
http://www.cisco.com/en/US/docs/switches/lan/trustsec/configuration/guide/arch_over.html#wp10545
61