Cisco Catalyst 3560-X Series, Software Configuration Manual

Page: 1283 / 1538

1-27
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Chapter 1 Configuring IP Multicast Routing
Configuring IP Multicast Routing
Beginning in privileged EXEC mode, follow these steps to deploy Auto-RP in an existing sparse-mode
cloud. This procedure is optional.
Command Purpose
Step 1 show running-config Verify that a default RP is already configured on all PIM devices and the
RP in the sparse-mode network. It was previously configured with the
ip
pim rp-address global configuration command.
This step is not required for spare-dense-mode environments.
The selected RP should have good connectivity and be available across
the network. Use this RP for the global groups (for example 224.x.x.x
and other global groups). Do not reconfigure the group address range that
this RP serves. RPs dynamically discovered through Auto-RP take
precedence over statically configured RPs. Assume that it is desirable to
use a second RP for the local groups.
Step 2 configure terminal Enter global configuration mode.
Step 3 ip pim send-rp-announce interface-id
scope ttl group-list access-list-number
interval seconds
Configure another PIM device to be the candidate RP for local groups.
•
For interface-id , enter the interface type and number that identifies
the RP address. Valid interfaces include physical ports, port
channels, and VLANs.
• For scope ttl , specify the time-to-live value in hops. Enter a hop
count that is high enough so that the RP-announce messages reach
all mapping agents in the network. There is no default setting. The
range is 1 to 255.
•
For group-list access-list-number , enter an IP standard access list
number from 1 to 99. If no access list is configured, the RP is used
for all groups.
• For interval seconds , specify how often the announcement messages
must be sent. The default is 60 seconds. The range is 1 to 16383.
Step 4
access-list access-list-number { deny |
permit } source [ source-wildcard ]
Create a standard access list, repeating the command as many times as
necessary.
•
For access-list-number , enter the access list number specified in
Step 3.
• The deny keyword denies access if the conditions are matched. The
permit keyword permits access if the conditions are matched.
•
For source , enter the multicast group address range for which the RP
should be used.
• (Optional) For source-wildcard , enter the wildcard bits in dotted
decimal notation to be applied to the source. Place ones in the bit
positions that you want to ignore.
Recall that the access list is always terminated by an implicit deny
statement for everything.