Cisco Catalyst 3560-X Series, Software Configuration Manual

Page: 846 / 1538

1-6
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Chapter 1 Configuring SNMP
Configuring SNMP
Note
The switch might not use sequential values within a range.
Configuring SNMP
•
Default SNMP Configuration, page 1-6
•
SNMP Configuration Guidelines, page 1-7
•
Disabling the SNMP Agent, page 1-7
•
Configuring Community Strings, page 1-8
•
Configuring SNMP Groups and Users, page 1-9
•
Configuring SNMP Notifications, page 1-12
•
Setting the Agent Contact and Location Information, page 1-16
•
Limiting TFTP Servers Used Through SNMP, page 1-17
•
SNMP Examples, page 1-17
Default SNMP Configuration
Physical (such as Gigabit Ethernet or SFP
2
-module interfaces) based
on type and port numbers
10000–14500
Null 10501 (nonstackable switches)
14501 (stackable switches)
Loopback and Tunnel 24567 +
1. SVI = switch virtual interface
2. SFP = small form-factor pluggable
Table 1-3 ifIndex Values (continued)
Interface Type ifIndex Range
Table 1-4 Default SNMP Configuration
Feature Default Setting
SNMP agent Disabled
1
.
1. This is the default when the switch starts and the startup configuration does not have any snmp-server global configuration
commands.
SNMP trap receiver None configured.
SNMP traps None enabled except the trap for TCP connections ( tty ).
SNMP version If no version keyword is present, the default is Version 1.
SNMPv3 authentication If no keyword is entered, the default is the noauth (noAuthNoPriv)
security level.
SNMP notification type If no type is specified, all notifications are sent.