Cisco Catalyst 3560-X Series, Software Configuration Manual

Page: 451 / 1538

1-49
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Chapter 1 Configuring Interface Characteristics
Configuring the Cisco eXpandable Power System (XPS) 2200
You use the switch CLI to configure the XPS:
• Configuring the System Names, page 1-49
•
Configuring XPS Ports, page 1-50
• Configuring XPS Power Supplies, page 1-51
Configuring the System Names
To configure a name for the XPS 2200 system and for an XPS port connected to a switch, follow these
steps beginning in privileged EXEC mode:
Use the no power xps switch-number name command to remove the system name. Use the no power
xps switch-number port command to remove the port name.
Command Purpose
Step 1 configure terminal Enters global configuration mode.
Step 2 power xps switch-number name { name |
serialnumber }
Configures a name for the XPS 2200 system.
• name —Enter a name for the XPS 2000 port. The name can have up
to 20 characters.
•
serialnumber —Use the serial number of the XPS 2200 as the system
name.
The switch-number appears only on Catalyst 3750-X switches and
represents the switch number in the data stack, a value from 1 to 9.
Step 3 power xps switch-number port { name |
hostname | serialnumber }
Configures a name for an XPS 2200 port connected to the switch.
• name —Enter a name for the XPS 2000 port.
•
hostname —Use the hostname of the switch connected to the port.
• serialnumber —Use the serial number of the switch connected to the
port.
The switch-number appears only on Catalyst 3750-X switches and
represents the switch number in the data stack, a value from 1 to 9.
Step 4 end Returns to privileged EXEC mode.
Step 5
show env xps system Verifies the configured name of the system and ports.
Step 6
copy running-config startup-config (Optional) Saves your entries in the configuration file.