26-4
Cisco ME 3800X and 3600X Switch Software Configuration Guide
OL-23400-01
Chapter 26 Configuring Network Security with ACLs
Understanding ACLs
Figure 26-1
Using ACLs to Control Traffic to a Network
When you apply a port ACL to a trunk port, the ACL filters traffic on all VLANs present on the trunk
port. You cannot apply a port ACL to a port configured with a service instance.
With port ACLs, you can filter IP traffic by using IP access lists and non-IP traffic by using MAC
addresses. You can filter both IP and non-IP traffic on the same Layer 2 interface by applying both an IP
access list and a MAC access list to the interface.
Note
You cannot apply more than one IP access list and one MAC access list to a Layer 2 interface. If an IP
access list or MAC access list is already configured on a Layer 2 interface and you apply a new IP access
list or MAC access list to the interface, the new ACL replaces the previously configured one.
Router ACLs
You can apply router ACLs on switch virtual interfaces (SVIs), which are Layer 3 interfaces to VLANs;
on physical Layer 3 interfaces; and on Layer 3 EtherChannel interfaces. You apply router ACLs on
interfaces for specific directions (inbound or outbound). You can apply one router ACL in each direction
on an interface.
One ACL can be used with multiple features for a given interface, and one feature can use multiple
ACLs. When a single router ACL is used by multiple features, it is examined multiple times.
The switch supports these access lists for IPv4 traffic:
•
Standard IP access lists use source addresses for matching operations.
•
Extended IP access lists use source and destination addresses and optional protocol type information
for matching operations.
Host A
Host B
101365
Research &
Development
network
= ACL denying traffic from Host B
and permitting traffic from Host A
= Packet
Human
Resources
network
