29-40
Cisco ME 3800X and 3600X Switch Software Configuration Guide
OL-23400-01
Chapter 29 Configuring IP Unicast Routing
Configuring EIGRP
Beginning in privileged EXEC mode, follow these steps to configure a remote or spoke router for EIGRP
stub routing:
Enter the show ip eigrp neighbor detail privileged EXEC command from the distribution router to
verify the configuration.
Monitoring and Maintaining EIGRP
You can delete neighbors from the neighbor table. You can also display various EIGRP routing statistics.
Table 29-8
lists the privileged EXEC commands for deleting neighbors and displaying statistics. For
explanations of fields in the resulting display, see the Cisco IOS IP Command Reference, Volume 2 of 3:
Routing Protocols, Release 12.2.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
router eigrp 1
Configure a remote or distribution router to run an EIGRP process and
enter router configuration mode.
Step 3
network network-number
Associate networks with an EIGRP routing process.
Step 4
eigrp stub [receive-only | connected |
static | summary]
Configure a remote router as an EIGRP stub router. The keywords have
these meanings:
•
Enter receive-only to set the router as a receive-only neighbor.
•
Enter connected to advertise connected routes.
•
Enter static to advertise static routes.
•
Enter summary to advertise summary routes.
Step 5
end
Return to privileged EXEC mode.
Step 6
show ip eigrp neighbor detail
Verify that a remote router has been configured as a stub router with
EIGRP. The last line of the output shows the stub status of the remote or
spoke router.
Step 7
copy running-config startup-config
(Optional) Save your entries in the configuration file.
Table 29-8
IP EIGRP Clear and Show Commands
Command
Purpose
clear ip eigrp neighbors [if-address | interface]
Delete neighbors from the neighbor table.
show ip eigrp interface [interface] [as number]
Display information about interfaces configured for EIGRP.
show ip eigrp neighbors [type-number]
Display EIGRP discovered neighbors.
show ip eigrp topology [autonomous-system-number] |
[[ip-address] mask]]
Display the EIGRP topology table for a given process.
show ip eigrp traffic [autonomous-system-number]
Display the number of packets sent and received for all or a
specified EIGRP process.
