34-60
Cisco ME 3800X and 3600X Switch Software Configuration Guide
OL-23400-01
Chapter 34 Configuring MPLS, MPLS VPN, MPLS OAM, and EoMPLS
Monitoring and Maintaining MPLS and EoMPLS
Monitoring and Maintaining MPLS and EoMPLS
To clear MPLS counters or display MPLS and EoMPLS information, use the privileged EXEC
commands in
Table 34-2
.
Step 19
copy running-config startup-config
(Optional) Save your entries in the configuration file.
Step 20
show ip sla monitor mpls-lsp-monitor
collection-statistics [group-id]
show ip sla mpls-lsp-monitor lpd
operational-state
(Optional) Displays the statistics for IP SLAs operations
belonging to an LSP discovery group of an LSP Health
Monitor operation.
Optional) Displays the operational status of the LSP
discovery groups belonging to an LSP Health Monitor
operation.
Note
These commands are applicable only if the LSP
discovery option is enabled.
Command
Purpose
Table 34-2
Commands for Displaying MPLS and EoMPLS Information
Command
Purpose
clear mpls counters
Clear MPLS forwarding counters.
clear mpls traffic-eng autotunnel primary
Remove all primary auto tunnels and recreate them.
show interface tunnel tunnel-number
Display information about the specified tunnel interface.
show ip explicit paths
Display the configured IP explicit paths.
show ip rsvp fast reroute [detail]
Display specific information for RSVP categories, including fast reroute.
show ip rsvp host
Display RSVP terminal point information for receivers or senders
show isis database verbose
Display information about the IS-IS database.
show isis mpls traffic-eng
Display information about IS-IS MPLS traffic engineering.
show mpls forwarding-table
Display the contents of the MPLS label forwarding information base
(LFIB).
show mpls interfaces
Display information about interfaces that have been configured for label
switching.
show mpls ip binding
Display specified information about label bindings learned by LDP.
show mpls l2transport vc [detail] [summary]
Display detailed or summary information about the EoMPLS virtual
connections that have been enabled to route Layer 2 packets on a
provider-edge device.
show mpls l2transport vc [vc-id] [vc-id-min -
vc-id-max]
Display information about the specified virtual connection or range of
virtual-connections. The range is from 1 to 4294967295.
show mpls label range
Display the range of local labels available for use on packet interfaces.
show mpls ldp backoff
Display information about the configured session setup backoff
parameters and any potential LDP peers with which session setup
attempts are being throttled.
show mpls ldp bindings
Display the contents of the label information base (LIB).
show mpls ldp discovery
Display the status of the LDP discovery process.
