32-12
Cisco ME 3800X and 3600X Switch Software Configuration Guide
OL-23400-01
Chapter 32 Configuring Ethernet OAM, CFM, and E-LMI
Configuring Ethernet CFM
Use the no form of each command to remove a configuration or to return to the default settings.
Step 3
service {ma-name | ma-number | vpn-id vpn} {vlan
vlan-id [direction down] | port}
Define a customer service maintenance association name
or number or a VPN ID to be associated with the domain,
and a VLAN ID or peer MEP, and enter
ethernet-cfm-service configuration mode.
•
ma-name—a string of no more than 100 characters that
identifies the MAID.
•
ma-number—a value from 0 to 65535.
•
vpn-id—enter a VPN ID as the ma-name.
•
vlan vlan-id—VLAN range is from 1 to 4094. You
cannot use the same VLAN ID for more than one
domain at the same level.
•
(Optional) direction down—specify the service
direction as down.
•
port—Configure port MEP, a down MEP that is
untagged and not associated with a VLAN.
Step 4
continuity-check
Enable sending and receiving of continuity check
messages.
Step 5
mep mpid identifier
Define the static remote maintenance end point identifier.
The range is 1 to 4094.
Step 6
continuity-check static rmep
Enable checking of the incoming continuity check message
from a remote MEP that is configured in the MEP list.
Step 7
end
Return to privileged EXEC mode.
Step 8
show ethernet cfm maintenance-points remote
static
Verify the configuration.
Step 9
show ethernet cfm errors [configuration]
Enter this command after you enable CFM crosscheck to
display the results of the crosscheck operation. Enter the
configuration keyword to display the configuration error
list.
Step 10
copy running-config startup-config
(Optional) Save your entries in the configuration file.
Command
Purpose
