34-59
Cisco ME 3800X and 3600X Switch Software Configuration Guide
OL-23400-01
Chapter 34 Configuring MPLS, MPLS VPN, MPLS OAM, and EoMPLS
Configuring MPLS OAM and IP SLAs MPLS
Step 14{
auto ip sla mpls-lsp-monitor
reaction-configuration operation-number react lpd
{lpd-group [retry number] | tree-trace}
[action-type trapOnly]
(Optional) Configure LSP Health Monitor tree trace actions:
•
operation-number—Enter the Health Monitor tree-trace
operation number.
•
react lpd—Specify LPD as the element to be monitored
for violations.
•
lpd-group— Enable monitoring of LSP discovery group
status changes.
•
retry number—Specify the number of times the
equal-cost multipaths belonging to an LSP discovery
group are retested when a failure is detected. The value
of the number argument is zero by default.
•
tree-trace—Enable monitoring of situations where LSP
discovery to a BGP next hop neighbor fails.
•
(Optional) action-type trapOnly—Specify the action to
take when the threshold event occurs as trapOnly to
send an SMNP logging trap.
Step 15
ip sla monitor logging traps
(Optional) Enable the generation of SNMP system logging
messages specific to IP SLAs trap notifications.
Step 16
auto ip sla mpls-lsp-monitor schedule
operation-number schedule-period seconds
[frequency seconds] [start-time {hh:mm {:ss}
[month day | day month] | pending | now | after
hh:mm:ss}]
Schedule the time parameters for the LSP Health Monitor.
•
operation number—Enter the IP SLAs MPLS LSP
monitor operation number.
•
schedule-period seconds—Enter the schedule period in
seconds. The range is 1 to 604800 seconds.
•
(Optional) frequency seconds—Enter the frequency for
LSP monitoring. The range is 1 to 604800 seconds.
•
(Optional) start-time—Enter the time for the operation
to begin collecting information:
–
To start at a specific time, enter the hour, minute,
second and day of the month. If no month is entered,
the default is the current month.
–
Enter pending to select no information being
collected until a start time is selected.
–
Enter now to start the operation immediately.
–
Enter after hh:mm:ss to indicate that the operation
should start after the entered time has elapsed.
Step 17
end
Return to privileged EXEC mode.
Step 18
show ip sla mpls-lsp-monitor configuration
[operation-number]
Show the configured LSP monitoring operations.
Command
Purpose
