27-35
Cisco ME 3800X and 3600X Switch Software Configuration Guide
OL-23400-01
Chapter 27 Configuring QoS
Configuring QoS
Step 4
police {rate-bps | cir {cir-bps
[burst-bytes] [bc burst-bytes]|
percent percent [burst-ms] [bc
burst-ms]} }
Configure a traffic policer based on the traffic rate or committed information rate
(CIR). By default, no policer is defined.
•
For rate-bps, specify average traffic rate in bits per second (b/s). The range is
64000 to 10000000000.
•
For cir cir-bps, specify a committed information rate (CIR) in bits per second
(b/s). The range is 64000 to 10000000000.
•
For burst-bytes (optional), specify the normal burst size in bytes. The range is
8000 to 16000000.
•
For bc burst-bytes (optional), specify the conformed burst (bc) or the number
of acceptable burst bytes. The range is 8000 to 16000000.
•
For cir percent percent, specify the rate as a percentage of the bandwidth
assigned to the class. The range is 1 to 100 percent.
•
For burst-ms (optional), enter the conform burst size in milliseconds. The
range is 1 to 2000. The default is 250 ms.
•
For bc burst-ms (optional), specify the conformed burst (bc) in milliseconds.
The range is 1 to 2000.
Note
If you are configuring a single action for conformed and exceeded packets,
you can specify them in the same line as the police command. If
configuring multiple actions, press ENTER after the police command, and
enter policy-map class police configuration mode (config-pmap-c-police)
mode to specify the actions to take.
Command
Purpose
