Christie RPMSP-D132U, User Manual

Page: 100 / 134

4-32 RPMSP-D132U & RPMSP-D180U User Manual User Manual
020-100245-03 Rev. 1 (11-2010)
Section 4: Advanced Configuration and Controls
4.17.3 System Warnings / Errors
When the projector encounters a system malfunction, a System Warning or a System Error message will appear.
These messages are accompanied by a numerical error code shown in the status display window. A system
malfunction can be cleared with from presentation level, but may indicate the need for service by a
qualified service technician. For best results reset the projector—power the projector down and up with the
(power) key. Wait at least 90 seconds and allow for proper cooling.
NOTE:
System messages appear on-screen only if Display Error Messages is set to “Screen” or “All” .
System Warnings
Indicates that a system malfunction exists. A system warning message replaces any input signal message and
disappears when the input signal status changes. While the projector will remain operational, the message
indicates a potentially serious problem that should be reported to the manufacturer. Reset the projector.
System Errors
Indicates that a serious malfunction exists and must be reported to the manufacturer as soon as possible. The
projector will no longer operate. Reset the projector.
The Status Display
If one of the error codes in table is shown in the status display window you have a system error that will require
the attention of a qualified service technician.
Acknowledge and clear the error with from presentation level, or try resetting the projector by
powering it off and on again, cooling when necessary. Consult and contact your dealer if the problem persists
or if you encounter a code not listed in this table.
For detailed information, monitor the RS-232 IN port. For an indication of engine communication failure, send
(SST? 1 15) to get a report.
Error Codes
q
CODE
q
DESCRIPTION
GENERAL
12 Software bug. Contact dealer/factory.
13 Flash memory corrupted. Download new software.
14 Engineering-only programming is complete. Call Christie, replace TIPM.
15 Attempting to download code without being in boot mode.
16 Invalid interrupt. Power off/on. If it persists, contact dealer/factory.
18 Attempting to program boot mode without jumper.
8C No communication with light engine.
8D Engine internal failure (all other failures).
Exit Exit
Exit Exit