Christie RPMSP-D132U, User Manual

Page: 41 / 134

Section 3: Operation
RPMX/RPMSP-D132U & RPMSP-D180U User Manual 3-7
020-100245-03 Rev. 1 (11-2010)
Channel
Select a source setup ( channel ) defined and stored in projector memory. Enter a 2-digit channel number, the
display will automatically update according to the setup parameters defined for that channel. A new channel is
automatically created if you adjust an image from a new source.
NOTE:
To display a list of available channels for selection make sure the Display Channel List option is
enabled in the Menu Preferences menu. See Menu Preferences later in this section.
Input 1
Displays the data or video input source connected to BNCs labeled
INPUT 1
.
Input 2
Displays the DVI source connected to
INPUT 2
.
Input 3
Displays the composite video source connected to
INPUT 3
.
Input 4
Displays the S-video source connected to
INPUT 4
.
Input 5
Displays the source connected to the
INPUT 5
interface module installed in the Option 1 slot.
NOTE:
With the optional Dual SD/HD-SDI Module installed at input 5 you can connect two inputs – A and B.
Whether you are displaying from input 5 or from another input, press
to display the input last used. Press
again to switch to the other input.
Input 6
Not applicable.
Contrast
Changes the amount of white in your images. Use keys until you reach the required level of
contrast—for best results, start low and increase so that whites remain bright but are not distorted or tinted, and
that light areas do not become white (“crushed”). Conversely, low contrast causes dim images. See
3.5
Adjusting the Image (Image Settings subsection) .
Channel
Input 1
Input 2
Input 3
Input 4
Input 5
Input 5
Input 5
Input 6
Contrast