Christie RPMSP-D132U, User Manual

Page: 28 / 134

2-16 RPMX/RPMSP-D132U & RPMSP-D180U User Manual
020-100245-03 Rev. 1 (11-2010)
Section 2: Installation and Setup
Connecting RS-422
To control the projector with a computer or other devices with RS-422 capability, connect an RS-422 serial
communication cable between the computer and the RS-422 port on the projector. RS-422 is better suited for
serial communication over long distances than RS-232 communication.
Use the RS-422 port only if your device has RS-422 capability. Consult the literature provided with your
equipment before connecting. Connecting to the RS-422 port with incompatible equipment could damage your
projector.
F
IGURE
2-18 C
ONNECTING
RS-422
2.4.3 Ethernet Communications
To add the projector to an existing Ethernet network, connect standard CAT5 Ethernet cable between your
Ethernet hardware and the Ethernet port on the side of the projector.
The project factory default is DHCP enabled, an IP address will be ob ta i ed automatically. If there is no
DHCP server available on the network or if a static IP address for the projector is required, set the address in
the
Ethernet Settings menu or via serial command.
Regardless of how it is assigned, once a projector has a valid and unique address it will respond to commands
sent to this address. To determine the projector’s current IP address, consult the
Status or Communications
menus.
Refer to
Section 3 for further information about setting up and using a projector connected via Ethernet.
F
IGURE
2-19 E
THERNET
C
OMMUNICATION