Christie RPMSP-D132U, User Manual

Page: 24 / 134

2-12 RPMX/RPMSP-D132U & RPMSP-D180U User Manual
020-100245-03 Rev. 1 (11-2010)
Section 2: Installation and Setup
F
IGURE
2-11 I
NPUT
P
ANEL
RGB signals (5 BNCs)
INPUT 1
has 5 BNCs for connecting a variety of sources. A typical connection would be to an RGB source such
as a PC, Mac, Sun, SGI and others. This projector supports multiple sync types: sync-on-green, composite
sync, and separate H & V syncs.
Connect the
SYNC
BNC input(s). H & V syncs may be connected in any order, the projector will auto detect
them. Then connect the red, green and blue source outputs to the
RED
,
GREEN
, and
BLUE
BNCs. If the source
uses sync-on-green, only the red, green, and blue connections are required. If the source provides a composite
sync output, connect it to the
SYNC
input labeled
HOR/COMP
. If the source provides separate horizontal and
vertical sync outputs, connect horizontal sync to the
SYNC
input labeled
HOR/COMP
and connect vertical sync
to
SYNC
input labeled
VERT.
See Figure 2-12 .
NOTES:
1)Depending on the source, you may need a custom adapter cable with BNC connectors at the
projector end and a different type of connector at the other (such as a 15-pin "D" connector for some computer
sources). Contact your dealer for details.
2) If the projector fails to recognize a signal as an RGB signal, specify the Color Space option within the Image
Settings menu. See
3.5 Adjusting the Image .
3) To connect YPbPr signals–such as from DVDs or analog HDTV sources–to INPUT 1, use the red, green and
blue BNCs as described in YPbPr Signals (below).