Christie RPMSP-D132U, User Manual

Page: 86 / 134

4-18 RPMSP-D132U & RPMSP-D180U User Manual User Manual
020-100245-03 Rev. 1 (11-2010)
Section 4: Advanced Configuration and Controls
Short cut: Press on the Remote if menu not present.
Toggle to display from two sources at once (Picture-in-Picture) or the primary source only. This checkbox
turns the secondary source on and off.
NOTE:
Disable PIP and Best Switching for Interlaced sources > 35kHz.
PIP Size and Position –
Submenu
Most controls in the PIP Size and Position menu adjust the PIP (secondary) image in the same fashion as their
counterparts in the main Size and Position menu adjust the main image—see 3.5 Adjusting the Image for
details. Exceptions are:
• POSITION PRESETS – Set the location of the PIP (secondary) image in the display.
• ASPECT RATIO PRESETS – Choose the desired aspect ratio for your PIP pixels. Use the “Default”
aspect ratio when incoming format has square pixels (most common). This makes sure that the resulting
PIP image maintains its intended aspect ratio. Use “Anamorphic” for NTSC signals having narrower pix-
els--this will stretch the pixels horizontally to regain the intended aspect ratio of the PIP image.
NOTE:
If the image is already resized at the source it will remain that way in the PIP window. If, for example,
an NTSC signal is already set to anamorphic through the Resize and Preset menu it will remain that way in the
PIP window. If the NTSC signal is formatted as widescreen at the source, then the image in the PIP window
will appear with black bars above and below it.
PIP Image Settings —
Submenu
Adjust the PIP (secondary image) without affecting the size or position. The primary image remains
unchanged. See
3.5 Adjusting the Image for details
PIP Border Width - Set the desired line thickness for your PIP window border.
PIP Border Color - Select the desired color for the PIP window border.
NOTES:
1) Numbers 7 and 8 on the Picture-in-Picture and Switching submenu control switching parameters.
2) Disable PIP to work with Seamless Switching.
3) Disable PIP and Best Switching for Interlaced sources > 35kHz.
4.11.2 Working with Seamless Switching
Seamless Switching is the ability to instantly and/or smoothly switch sources, and is controlled with options 7
and 8 in the
PIP and Switching menu. To use Seamless Switching, PIP must be disabled.