Christie RPMSP-D132U, User Manual

Page: 71 / 134

Section 4: Advanced Configuration and Controls
RPMSP-D132U & RPMSP-D180U User Manual User Manual 4-3
020-100245-03 Rev. 1 (11-2010)
4.7 Communications
Settings in the Communications submenu define and control how single or multiple projectors can link with
each other and with a controlling device.
F
IGURE
4-3 C
OMMUNICATIONS
S
UBMENU
4.7.1 Baud Rates
The baud rate setting determines the speed of communication to and from the projector on the RS-232 or RS-
422 links. Set the baud rate to match that of your controlling device, such as your PC. If you are unsure about
what baud rate to choose, refer to the documentation for the controlling device. In a network of projectors, if a
projector has a different baud rate use the pull-down list and select the correct baud rate using the key. Do
not just scroll this control with
or
keys. Serial communication is 8 data bits, no parity, one stop bit.
4.7.2 Projector
Enter a three-digit number (such as “001”) to assign or change a number to the projector currently in use. If the
current projector already has a number assigned, that number will appear instead. Numerical identity for
projectors enables you to communicate with a single projector within a multiple-projector application (see also
DISPLAY ERROR MESSAGES
Choose how you want to be notified of errors detected in either the incoming
signal or projector. Select “Screen” or “All” to see a brief on-screen message or
select “RS-232” to receive messages via RS-232 (or RS-422) serial communica-
tion only. Select “Off” to hide error message displays.
SPLASH SCREEN SETUP Choose when you would like to display a special introductory splash screen
image, such as your company logo, graphic or message.
• Always Off = A splash screen never appears
• Always On = A splash screen is always on behind the current display
image, similar to wallpaper.
• Start-up Only – The splash screen logo appears at projector start-up
only.
• Start-up And No Signal – A splash screen appears at start-up only if
there is no source signal.
To replace the default splash screen use KoRE Librarian to download the desired
image to the projector. This will overwrite the current splash screen content in
projector memory.