－
32
－
5. LOADING
5.2 Cartridge Pen Loading (For pen type)
Note) If the pen pointer do not move to the specified position,
“ENTRY ” key may not be pressed while pressing down the
“
◄
”
key (in this case, it may be in the Chart Speed Change
mode, refer to 6.6 Chart Speed Change). Operate from
Operation mode again.
2) Lift up of the 1st pen scale plate
Only for the 1st pen scale plate of the 3 pen specification,
structure allows scale plate to move.
For 3 pen specification, when replacing the cartridge pen of the
1st pen, lift the scale plate up and perform cartridge pen loading.
For lifting up the scale plate of the 1st pen, lift up lower part ((the
part directed by the hand in the figure below) of lower limit side
(left side) of the scale plate. The scale plate would be up until
lower part of the scale plate of 2nd plate.
3) Load /Replacement of the Cartridge Pen
1. Remove the cap of the pen, bring the color line in the front then
insert protruding portion of the right side into the hole of the pen
holder. Turn the cartridge pen clockwise to load to the pen
holder.
At this time, state of lifting the cartridge pen slightly while
protruding portion of the right side of the cartridge pen is inserted
into the hole of the pen holder creates easy performance.
2. To remove the cartridge pen, turn the cartridge pen
counterclockwise with slightly pushing the protruding portion of the
left side of the cartridge pen.
Pen cap is used when not recording for long time so keep the pen
cap carefully.
4) Return to the Operation Mode
1. After loading/replacement of the cartridge pen, press “MODE”
key.
2. Finish the pen replacement mode and return to the operation
mode.
3 pen specification: the scale plate of the 1st pen is lifted up
For lifting up the 1st pen scale plate of the 3 pen specification,
make sure to perform operation at the far left side. If the
operation is done by position other than this, scale plate may be
deformed and cause errors and failures.
Also, the scale plate stops at the stopper position. If the scale
plate is lifted up more than stopper position, it may cause failure
and damage.
Do not move blank scale plate (without scale printing) of the 2
pen specification located at the bottom. The scale plate may be
deformed and cause errors and failures.
For moving scale plate
Do not load the cartridge pen while pen cap is on. It may cause
errors and failures.
Removing the pen cap
Figure of cartridge pen loading
Pen holder
Cartridge pen
Pen cap
Color line
Tip of the cartridge pen is made of nylon fiber. Do not crush the tip
of the pen.
Handling of the pen tip
