20
the handle vertically (Fig. 25), press the two grey but-
tons on the lateral joints (fig. 25A) and lift the semi-rigid
carrycot holding the handle (fig. 25B).
26. Once the semi-rigid carrycot accommodating your
child is removed from the stroller frame, it can be placed
on a flat surface (Fig. 26).
To return to the stroller or pram configuration, it is neces-
sary to remove the fabric lining and the semi-rigid carrycot
base previously fitted.
To remove the base, repeat the assembly operations previ-
ously described (see point 24) in reverse order.
27. Once removed from the seat, the base can be folded on
itself to make it more compact acting on the two sliding
buttons in the lower part at the same time (Fig. 27).
WARNING:
When not in use, keep the rigid base out of
reach of children.
COMFORT KIT
28. Included with the seat is a comfort kit including two
shoulder straps and a crotch strap (Fig. 28).
29. For assembly, insert the shoulder straps (Fig. 29) and the
crotch strap in the relevant padding (Fig. 29A).
LEGCOVER / PRAM APRON
30. This component can be used in two different ways: as
legcover in stroller configuration (Fig. 30) and as an apron
in pram/semi-rigid carrycot configuration (Fig. 30A).
31. In the stroller configuration, lay the cover on the frame
and fasten the two external side buttons (Fig.31). For
greater protection, it is possible to lift the fabric flap of
the cover by fastening it to the slots on the inner sides
of the hood using the buttons (fig.31A).
32. In stroller configuration, insert the leg cover, making
sure that the fabric pocket remains under the legrest/
seat (Fig.32). Then fasten it to the two external side but-
tons (Fig. 32A).
RAIN COVER
33. The stroller is equipped with a rain cover. To secure the
rain cover, completely open the stroller’s hood and
wrap the raincover around the external tube of the seat
(Fig. 33). After use, hang the rain cover to dry (if it is wet)
before folding and storing it away out of the reach of
children.
WARNING:
Use the rain cover supplied and mounted on
the hood fully open. The rain cover cannot be used on the
stroller without the hood; it may represent a suffocation
hazard for the child.
WARNING:
The rain cover supplied must be used under
the supervision of an adult.
WARNING:
The rain cover supplied should only be used
on the Fully stroller.
WARNING:
When it is being used, make sure the rain cover
does not come into contact with your child’s face.
When the rain cover is fitted on the stroller, never leave it
exposed to direct sunlight with the child inside, as the tem-
perature will rise considerably.
USING ADAPTORS “4”
34. The adapters marked with the number “4” are necessary
to prepare fitting the Chicco Keyfit car seat (sold sepa-
rately) on the rear legs of the stroller. These adaptors can
only be fitted on the rear legs of the stroller. For correct
installation, make sure that the symbols on the frame
match in order to be able to fit the relative adaptors (Fig.
34-34A). Make sure that the adaptors are fit on the tube
and adhere to the plastic component of the rear wheel
assembly (Fig.34B).
WARNING:
The seats MUST NOT be installed on the adap-
tors “4”.
After purchasing the child car seat, for use on the frame
it is necessary to purchase the special “KeyFit adaptor for
Fully” (sold separately) and refer to the relative instruction
manual.
35. The Fully stroller can be used in combination with two
seats, with two child car seats using the special “KeyFit
adaptors for Fully” (sold separately), or in mixed configu-
rations with child car seat and seat. Figures 35-35A-35B-
35C-35D-35E show all the possible options in double
configuration with relative description of the elements
required for assembly.
WARRANTY
The product is guaranteed against any conformity defect in
normal conditions of use as provided for by the instructions.
The warranty shall not therefore apply in the case of dam-
age caused by improper use, wear or accidental events. For
the duration of the warranty on conformity defects please
refer to the specific provisions of applicable national laws in
the country of purchase, where appropriate.
Summary of Contents for FULLY Twin
