Challenge TITAN 265 XG, Operator'S Manual

Page: 38 / 52

6.0 Operation
38
To insert a send value, press the soft-key “E” (Insert). This moves all send values down and provides
a blank line after the current send value.
Send values can also be entered using the “Cut and Record” feature. Move the cursor to the line
where the send values are to be inserted. Then press soft-key “D” (Cut & Rec). “C & R” will appear
in the upper right corner of the left display. Each cut will add the current backgauge position as a
send value. When finished, press soft-key “D” (Cut & Rec) again to exit cut & record mode. If there
is a blank line where the cursor is, press the down arrow and it will disappear.
To erase a send value, press the soft-key “G” (Erase). This will remove the cut value currently being
pointed to by the cursor. To backspace over the current send value without removing the line, press
the left arrow key.
When finished editing the job, you may exit the current job by pressing soft-key “F” (Job) to go back to
the job mode screen or soft-key “H” (Exit) to exit to send mode. Or you may use the job for cutting
since it is already open.
6.17.6 Running a Programmed Job
To use an existing job for cutting, you must first open it by using one of two methods: move the
cursor to the desired job with the arrow keys and press ENTER, or enter the job number with the
keypad and press ENTER. Once a job has been opened, the current job name and number will be
displayed in the upper right corner. Now press SEND to move the backgauge to the first programmed
position (or send value). Make a cut by pressing both cut buttons. Once the cut is made, the
backgauge will automatically push out the paper (only if the next position is larger than the current
one, and if “push-out” is enabled) and move to the next programmed position. If the job was created
using the “Sheet Division” feature, the left screen will display a diagram of where to place the paper
for each cut. After the last cut in the job is made, the backgauge will move to the first cut position of
the current job. Pressing SEND at any time during the job will send the backgauge to its next
programmed position without making a cut. A plus “+” sign will be displayed at the bottom of the
screen if more cuts remain in the current job.
6.17.7 Exiting a Job
To exit an open job, press the soft-key “F” (Job) to return to the job mode screen, or press the soft-
key “H” (Exit) to exit to the send mode screen.
Clamp
Pressure
| | | 14 | | |
-------------------------------
A) Division
D) Cut & Rec
5.070
in 8.5 X 11
L # 7
1> 8.500
2>11.000
E) Insert
G) Erase
F) Job H) Exit
Job
Name
Lock
Status
Job #