Challenge TITAN 265 XG, Operator'S Manual

Page: 29 / 52

6.0 Operation
29
6.14.1 Entering Math
In the simple send mode, the Titan 265 XG is capable of calculating an entire math string such as,
10-5+5x6+2_3/4. However, the result is limited to 29999.000 and the result cannot be a negative
value. In the job mode, and during a send, the result of the calculation must be less than the
backgauge limit of 30.500 inches.
6.14.2 Entering Fractions
Fractions are entered with the priority add key X/Y. The symbol displayed when this key is pressed is
the underline symbol “_”. This instructs the computer to add the fractional portion of the entry before
performing the remaining math. This key is useful when entering a formula as follows: 3x2_3/4 =
8_1/4. If a simple plus had been used instead, the result would be as follows: 3x2+3/4 = 6_3/4.
6.15 Repeat Mode
This mode allows the operator to make a series of cuts during which the backgauge moves a
specified distance between each cut. To enter repeat mode, press soft-key “H” (Repeat). The
display will then look like the one next:
Type in the desired initial backgauge position and press ENTER. The backgauge will then move to
that position. Then type in the step value and press ENTER. Position the paper and make a cut.
The backgauge will then move forward by the step amount, and a new cut can be made. When
finished, press soft-key “H” (Exit) to exit back to send mode.
Clamp
Pressure
| | | 14 | | |
-------------------------------
C) Up
D) Down
5.070
in
ORIGIN
>_
STEP
Initial
Position
H) Exit