5.0 Installation & Setup
16
Figure 11
The hydraulic fluid should be checked weekly and changed AT LEAST ONCE-PER-YEAR or after
every 1,000 hours of operation.
5.6 Optional False Clamp Plate
To prevent marking on pressure sensitive jobs, a false clamp plate is available as an optional item for
your machine. This plate attaches to the bottom of the clamp. It is secured with (3) setscrews
located in holes on the lower front face of the clamp.
To install:
1. Make sure the knife and clamp are in the up position. If they are not, turn on the power using
the red and yellow main power switch. Press the CLEAR button. This will preset the
backgauge and send the knife and clamp up.
2. REMOVE KNIFE. See Section 7.1 Knife Removal, page 41.
3. Turn the power off and disconnect the power cord.
4. Slide the false clamp plate under the clamp and slide the plate up into position.
5. Hold the plate in position and secure with the (3) setscrews located in the lower front face of
the clamp, Figure 12.
6. A sensor detects that the false clamp is installed and the computer setting will automatically
be set to ON.
NOTE: The minimum cut with the false clamp plate attached is 1-7/8”.
Figure 12
Sight
Gauge
False Clamp Plate
Set Screws
Summary of Contents for TITAN 265 XG
Page 47: ...7 0 Knife Installation Changing 47 NOTES...
Page 52: ...F 265XG EO January 2014...
