6.0 Operation
30
6.16 Maintenance Mode
The maintenance mode is an area where many machine functions can be set or modified. The four
principle functions are: Language, Parameters, Diagnostic, and Knife Adjust. To select a particular
function, use the up and down arrow keys to toggle to the desired function and press ENTER. See
the following descriptions for an explanation of each function.
6.16.1 Language
In the language screen, use the up and down arrow keys to toggle to the desired language, and press
ENTER. All messages will be displayed in the selected language.
6.16.2 Parameters
In the parameter screen, use the up and down arrow keys to toggle to the desired parameter, and
press ENTER. See the descriptions that follow for an explanation of each parameter.
6.16.2.1 False Clamp
The Titan 265 has a sensor that determines when the false clamp plate is installed. This parameter
shows whether the false clamp is installed or not.
6.16.2.2 Time-out
This parameter sets the amount of idle time for which the screen saver activates and the line lights
and hydraulic motor turn off. The choices are 2, 5, 10, 20, and 30 minutes. In the time-out screen,
use the up and down arrow keys to toggle to the desired time-out, and press ENTER.
6.16.2.3 Push-out
Normally, whenever the backgauge is sent to a larger dimension, a five-inch (127mm) push-out is
performed to aid the operator in accessing the paper. In some situations, it may be necessary to turn
this feature off. It is recommended that this feature be left on whenever possible. In the push-out
screen, use the up and down arrow keys to toggle to the on or off status as desired, and press
ENTER.
6.16.2.4 Accuracy Adjust
This parameter provides a means for adjusting the accuracy of the backgauge. To change the
accuracy, send the backgauge to 2 inches (50.8mm) and cut some paper. Measure the paper, and
Clamp
Pressure
| | | 14 | | |
-------------------------------
C)
Up
D) Down
5.070
in
MAINT
MENU
LANGUAGE
PARAMETERS
DIAGNOSTICS
KNIFE
ADJUST
Select and press enter
G)
Send
F)
Job
H)
Exit
Summary of Contents for TITAN 265 XG
Page 47: ...7 0 Knife Installation Changing 47 NOTES...
Page 52: ...F 265XG EO January 2014...
