Challenge TITAN 265 XG, Operator'S Manual

Page: 22 / 52

6.0 Operation
22
6.0 Operation
IMPORTANT: DO NOT ATTEMPT TO OPERATE THE CUTTER UNTIL YOU HAVE THOROUGHLY
READ AND UNDERSTAND ALL OF THE FOLLOWING INSTRUCTIONS. CALL YOUR
AUTHORIZED CHALLENGE DEALER IF YOU STILL HAVE ANY QUESTIONS.
6.1 Power - Main Power Switch
Figure 17
Power is brought to the machine when the main power switch is turned to the “ON” position (Figure
17). The display and line lights are turned on at this time.
The screen saver will activate and the line lights will shut off after 5 minutes without any activity. This
shut-off time can be changed in the Parameters screen of the Maintenance Mode (see the “Operating
Controls/Maintenance Mode/Parameters/Time Out” section). To restore power to the display and line
lights, press any button on the keyboard.
6.2 Start Up
Once power has been turned on, the display will show the following:
When the CLEAR key is pressed, the backgauge will move to coordinate the true position into the
computer (if the knife and clamp are not in the “up” position, the display will prompt the operator to
raise them by pressing the cut buttons prior to presetting the backgauge). When finished, the
machine will be in “Send Mode” and the display will appear similar to the display shown next:
Clamp
Pressure
| | | 14 | | |
-------------------------------
C) Up
D) Down
55.000
in
>_
Backgauge must move to be
preset. Please clear the table.
Revision 1.0
Press clear to start
E)
Maint
F) Job H) Repeat