Challenge TITAN 265 XG, Operator'S Manual

Page: 26 / 52

6.0 Operation
26
6.12.2 IN/MM Key
This key toggles the display to show the position and programmed send values in inches (e.g. 5.250),
inch fractions to the nearest 1/64” (e.g. 5_
1 /
4
), or millimeters (e.g. 133.3).
6.12.3 Air Table ON/OFF Key
This key turns the air table on and off.
6.12.4 Send Key
The SEND key is used to send the backgauge to any valid position. If an attempt is made to send the
backgauge to an illegal position, an error message will be displayed at the bottom of the screen
stating “Number outside limit”. In the Job mode, the SEND key will also advance the backgauge to
the next sequential cut position before performing the cut.
6.12.5 Push-Out Key
The push-out key will move the backgauge forward 5 inches (or to the most forward position) and
then return it to its previous position. This allows paper to be removed from the cutter without putting
hands under the knife and clamp.
Never place hands in the clamp and knife area. Use the push-out key or
the backgauge glide control to move the paper to an area where it can be reached.
6.12.6 Clear Key
The CLEAR key is used to clear error messages and the current entry line.