Challenge TITAN 265 XG, Operator'S Manual

Page: 34 / 52

6.0 Operation
34
backgauge as a send value, 3) Use the “Cut and Record” feature (described later) or 4) Use the
“Sheet Division” feature.
6.17.4.2 Creating a Stock Loading Position
After typing a send value, pressing the right arrow key instead of ENTER will move the cursor to the
right and prompt the operator to enter a rotation indicator mark or Load Zone (LZ). Selecting LZ will
make it impossible to cut at that position. Pressing both cut buttons on a position marked at a
Loading Zone will prompt the backguage to move to the next position in the job. Using a loading
position eliminates the need to reach into the knife/clamp area of the cutter when loading a job.
6.17.4.3 Entering Rotation Mark
After typing in a send value, pressing the right arrow key instead of ENTER will move the cursor to
the right and prompt the operator to enter a rotation indicator mark. The display will look similar to the
one shown next:
Use Soft Keys “C” and “D” to choose a turn indicator. Pressing ENTER will place an indicator mark to
the right of the send value, as shown below:
When the desired indicator mark is in place, press the right arrow key. The cursor will move to the
right and prompt the operator to enter a clamp pressure (see the following section).
NOTE: All new entry lines will have the same turn indicator mark as the one above it, until it is
changed.
Turn Indicator
Off
ccw
>
cw <
180 Turn >>
Load Zone LZ
Select & Press Enter
C) Up
D) Down
5.070
in JOB1
#1
1> 5.070 _
H) Exit
Clamp
Pressure
| | | 14 | | |
-------------------------------
C)
Up
D) Down
5.070
in JOB1
#1
1> 5.070 >>
H) Exit