Challenge TITAN 265 XG, Operator'S Manual

Page: 15 / 52

5.0 Installation & Setup
15
Figure 10
5.4.7 Attaching the Electric Eyes
Make sure power is disconnected from the machine. If necessary, connect the wires to the power
panel. Attach electric eye assemblies with provided hardware, making sure that the bottom of the
electric eye housings are parallel to the table. Once power is hooked up, the electric eyes should be
checked for alignment. See the Titan 265 Technical Service and Parts manual for information on how
to do this.
5.4.8 Attaching the Footswitch
Make sure power is disconnected from the machine. Attach the footswitch bracket using the
mounting hardware (Figure 9, page 14).
5.5 Hydraulic System Check
The Titan 265 is powered by a hydraulic system consisting of an electric motor coupled directly to a
hydraulic pump.
The hydraulic reservoir holds 5 gallons of hydraulic fluid. It is filled with Tellus #46 hydraulic fluid at
the factory but should be checked before operation. Remove the lower rear panel cover. Check the
sight gauge on the rear side of the hydraulic tank. Fluid should just be visible in the sight gauge
(Figure 11, next page). Add fluid if necessary, but avoid overfilling. For more information about
checking and changing the hydraulic fluid, including a cross-reference chart of approved fluids, See
the Titan 265 Technical Service and Parts manual. When finished, replace the panel.